Edgun R3M and R3 Degasser Tool M39

This tool makes degassing the Edgun R3M and R3 safe and easy. It also acan also be used to pull out the regulator.

Instructions:

• before screwing the tool onto the Edgun, back out the screw a little to allow the valve pin to go into the tool. 
• screw the tool onto the valve
• Using the blue knob slowly screw into valve pin. You'll start to hear a hissing noise and that's the air being released. 
• once empty, your gauge should be down to zero
• to remove the regulator, make sure the gun is completely empty. Unscrew the screws holding the regulator in place.
• Once all the screws are out, screw the degasser tool onto the valve and pull it out of the air tube